Comtrol RocketPort Serial Hub Si Driver Installation for W Manual de usuario descargar pdf (Pagina 31)

Changing Printer Port Configuration 31

9. The port selection page displays again. Click

10. Optionally, enter a custom name for this printer, and select whether this printer is the Windows default

printer. Click

11. Select whether to print a test page and click

Finish

Note: You may be prompted to insert the Windows 95/98 CD-ROM in order to load drivers. Do so and follow

the on-screen instructions.

12. If the test page prints successfully, you are now ready to begin using the printer. No reboot is needed.

Changing Printer Port Configuration

If the printer does not successfully print the test page, it may be necessary to change the port baud rate,

parity, and so on. If the Ports applet does not configure the port properly, you may have to use the mode

command from a DOS prompt. Also, check the printer for DIP switches or other hardware configuration

options.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 46 47

Sin comentarios

Comtrol RocketPort Serial Hub Si Driver Installation for W Manual de usuario Pagina 31