Comtrol RocketPort Serial Hub Si Driver Installation for W Manual de usuario descargar pdf (Pagina 13)

Installing the Device and Driver 13

h. If you need to configure RTS options, click on the RS Toggle tab.

i. Configure the port.

The

Override and lock to RTS toggle mode

option allows you to lock the port in RTS toggle mode,

then set the mode (low or high) as desired.

The

RTS Toggle RTS Low

option allows you to toggle the RTS output signal low during data

transmission. If the option box is not checked, RTS is toggled high (asserted) during data transmission

24. After configuring your port (COM) properties, click the OK button. The Main Setup screen returns.

25. If you did not clone all the COM ports, repeat Steps 21

through24 until all of the COM ports that you

want to use are configured.

26. Click on the OK button after configuring each port.

27. When you are finished configuring ports, click

to save your changes and exit from the Main Setup

window. At this point, you should be ready to begin operations. No rebooting is necessary.

Each RocketPort Serial Hub Si must be added individually.

• To add another RocketPort Serial Hub Si, repeat the above procedure.

• To complete configuration, you may need to set up modems or printers. See the appropriate subsections

later in this document.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 46 47

Sin comentarios

Comtrol RocketPort Serial Hub Si Driver Installation for W Manual de usuario Pagina 13