Comtrol NS-link Windows NT Manual de usuario descargar pdf (Pagina 9)

100

Overview 9

Device Preparation for NS-Link

Use the appropriate table to verify that your hardware was installed properly and

is ready for NS-Link installation. See the hardware installation documentation

(Page 6) if you need to install the hardware.

• DeviceMaster Serial Hub LEDs (below)

• DeviceMaster RTS LEDs

on Page 10

• DeviceMaster

PRO LEDs on Page 11

• RocketPort Serial Hub

ia LEDs on Page 11

• RocketPort Serial Hub

Si LEDs on Page 11

DeviceMaster Serial

Hub LEDs

Use this table to verify that your DeviceMaster Serial Hub is ready for NS-Link

installation.

Model

How to tell if the DeviceMaster Serial Hub is working

properly:

DeviceMaster

Serial Hub 8

•The PWR LED on the front of the unit is lit, which indicates

it has power and has completed the boot cycle.

Note: The PWR LED flashes while booting and it takes

approximately 15 seconds for the bootloader to

complete the cycle.

•The red LNK/ACT LED is lit, which indicates a working

Ethernet connection.

•If the red 100 LED is lit, it indicates a working 100 MB

Ethernet connection (100 MB network, only).

DeviceMaster

Serial Hub 16

•The Status LED on the front of the unit is lit, which indicates

it has power and has completed the boot cycle.

Note: The Status LED flashes while booting and it takes

approximately 15 seconds for the bootloader to

complete the cycle.

•The red LNK/ACT LED is lit, which indicates a working

Ethernet connection.

•If the red Duplex LED is lit, it indicates full-duplex activity.

•If the red 100 LED is lit, it indicates a working 100 MB

Ethernet connection (100 MB network, only).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 99 100

Comentarios a estos manuales

Sin comentarios

Comtrol NS-link Windows NT Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Software Comtrol NS-link Windows NT