Comtrol NS-link Windows NT Manual de usuario descargar pdf (Pagina 44)

44 Updating, Adding, or Removing NS-Link Devices

Adding Additional Devices

Install the device and configure the ports using the same procedures in Initial NS-

Link Installation on Page 13.

Removing an Existing Driver

Use the appropriate procedure for your environment.

Windows XP and

Windows 2000

Use the following procedure to remove any existing NS-Link device driver for the

Windows XP or Windows 2000 operating systems.

1. From the Start button, right-click on My Computer, and select Manage from the

shortcut menu.

2. In the Tree panel of the Computer Management window, highlight Device

Manager.

3. Expand the Multi-port serial adapters entry to view the list.

4. Right-click on the device you want to remove and select the Uninstall menu

item.

5. Select Ok at the Confirm Device Removal popup.

6. Close the Device Manager window and resume normal operations.

Windows NT Use the following procedure to remove the existing Windows NT driver. If

updating (not reconfiguring) NS-Link for Windows NT, make sure that you remove

the existing version before installing an updated driver.

Note: Using the Remove button on the

Comtrol Main Setup sheet only

discards the software

configuration, it does not remove

the software.

1. Right-click on the Network

Neighborhood, and select Properties.

2. Select the Adapters tab.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 99 100

Sin comentarios

Comtrol NS-link Windows NT Manual de usuario Pagina 44