Comtrol NS-link Windows NT Manual de usuario descargar pdf (Pagina 89)

Appendix A. Windows NT Configuration Overview 89

Adding or Reconfiguring a RAS Device

3. Highlight Remote Access Service

and select the OK button.

4. Enter the location of the

Windows NT files (for example,

d:\i386) and press the Continue

button.

The appropriate files are copied

onto your hard drive.

The RAS installation process

automatically launches the Add

RAS Device process. Go to

Adding or Reconfiguring a RAS

Device on Page 89, Step 5.

Note: If you install or reinstall RAS from your original Windows NT 4.0

distribution media, you must install or reinstall the latest Windows NT

Service Pack after installing/reinstalling RAS. This is necessary because

most Service Packs include RAS-related files that are newer than the files on

the NT distribution media.

Adding or

Reconfiguring a

RAS Device

There are several different ways to start this procedure:

• If you have previously installed RAS and configured at least one RAS device,

and are now adding or reconfiguring RAS devices, begin with Step 1

• If you have previously installed RAS and were in the process of installing a

modem when this process started automatically, begin with Step 3

• If you were in the process of installing RAS when this process started

automatically, begin with Step 5

Follow these steps:

1. Open the Control Panel and start the

Network applet, or right-click on the

Network Neighborhood and select

Properties. The Network window

displays.

2. Select the Services tab.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 99 100

Sin comentarios

Comtrol NS-link Windows NT Manual de usuario Pagina 89