Comtrol SCO OpenServer Manual de usuario descargar pdf (Pagina 14)

14 Installing the New Driver

SCO OpenServer

If you do have one or more RocketModem boards installed, press Y,

then select the code for the country where the modem will be used.

Values are:

F France

G Germany

I Italy

S Sweden

K United Kingdom

U USA/North America

12. If you do not have a RocketPort 485 board installed in your

system, press N.

If you do have a RocketPort 485 installed, press Y. Each port that

can be configured for RS-485 is then displayed; press Y if the port

is configured for RS-485, or N if the port is configured for RS-232.

Note: Only the first two ports on a RocketPort 485 can be set up

for RS-485. The remaining ports are always RS-232. To

determine how the board is configured, see the RocketPort

485 Hardware Reference Card.

13. Press Y to boot this new kernel by default.

14. Press Y to rebuild the kernel environment.

15. Press any key to continue.

16. Remove the device driver installation diskette.

17. Select Host and Exit to exit the custom utility.

18. Reboot the system so that your driver changes will take effect.

Rebooting the System

If you need to install new hardware, follow these steps:

1. At the root prompt, enter haltsys and press Enter. A screen displays

saying you can safely shut off your system.

2. Turn the system off and install the new hardware.

3. After installing the new hardware, turn the system back on.

If you do not need to install new hardware, enter reboot at the root

prompt and press Enter.

Alternately, you can sync, shutdown, and reboot the system by entering

this command:

shutdown -y -g0

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Sin comentarios

Comtrol SCO OpenServer Manual de usuario Pagina 14