Comtrol Multiport Modems Windows 2000 Manual de usuario descargar pdf (Pagina 12)

Driver and Adapter Information 12

Setting I/O Addresses and DIP Switches (ISA Only)

Setting I/O

Addresses and DIP

Switches (ISA Only)

This discussion concerns ISA adapters only. This driver supports only one ISA

adapter. When you install an ISA adapter, you must set the base I/O address in

two places

•In the driver software

• On the adapter itself, using a block of DIP switches.

Software I/O

Address

During installation, the software base I/O address is set to default values by the

Add/Remove Hardware Wizard.

After you finish the software installation, you can use the Device Properties

Resources tab to view or change the Input/Output Range resource setting. If the

default values prove incorrect:

1. Select the Input/Output Range from the Resource Type list.

2. Select the Change Setting button.

3. You may need to choose a hardware configuration from the Setting Based On

drop-down list box to activate the Edit Input/Output Range widow.

Note: The I/O range setting is based on your hardware configuration setting. You

can have multiple hardware configuration settings, and this control may be

locked in some configurations.

Hardware I/O

Address

The hardware base I/O address is set using a block of DIP switches on the adapter

circuit board. See your Hardware Installation

documentation for instructions on

how to set the DIP switches.

The software and hardware I/O address settings must match each other. For

example, if you set the DIP switches to 180 (hex), you must select 180 (hex) in the

software.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Sin comentarios

Comtrol Multiport Modems Windows 2000 Manual de usuario Pagina 12